top of page

OUR SOLIDS SEPARATORS FROG SERIES

 

Filtration devices / system that significantly reduce the load of wet waste solid matter typically contained in the amount of wastewater used by commercial kitchens at all wash sink areas.

MINI.jpg
"MINI FROG" SOLIDS SEPARATORS 

​

This Unit can accommodate installations at locations where space is limited. Provides continuous filtration of solid particulate that eventually accumulate causing pipe blockages, as well as reducing the load of solids inside the grease trap. Inlet and outlet pipes of 1.5” tp 2.0” are easily fitted to the durable co-polymer polypropylene housing. Drainage capacity of this device handles standard kitchen volumes based on pipe sizes. 

​

SEAL.png
mini_frog.jpg
MINI FROG / Typical Installation.

​

​

​

"THE FROG" SOLIDS SEPARATOR

​

 

This Unit typically fits 90-95% of regular commercial kitchen set ups. Application provides continuous filtration of solid particulate that eventually accumulate causing clogged pipes and unnecessary load of solids inside grease traps. Inlet and outlet pipes of 1.5” tp 2.0” are easily fitted to the durable co-polymer polypropylene housing. Drainage capacity of this device handles standard kitchen volumes based on pipe sizes.

​

​

MAXI.jpg
SEAL.png
"THE FROG" Typical Installation.
​

​

​

the_frog.jpg
COMBO.jpg
SEAL.png
"THE TAZ" COMBO UNIT

​

Introducing the world’s first "Combination Solids Separator and Grease Trap" device. The Unit may be incorporated with either the FROG or Mini FROG Units. All units are custom built to fit the space where the units is to be placed.

​

​

taz.jpg
"THE TAZ" Typical Installation.

​

​

​

​

"HOPPING FROG" SOLIDS SEPARATORS

​

Another world’s first, introducing the Mobile Solids Separator. This device is used in commercial kitchens that operate with one or multiple cauldrons / steam pots. The unit is placed directly under the evacuation faucets of various types of cooking cauldrons. This device can be placed wherever needed to filter solid particulate out of floor drains typically installed in front of each cauldron.

MOBILE.jpg
SEAL.png
"HOPPING FROG" Typical Installation.

​

​

mobile.jpg
GREASETRAPS.jpg
SEAL.png

"GREASE FROG" SERIES

 

Our Grease Traps can be installed above ground sitting on the floor, or flush to the floor in concrete. The units are produced according to specific sizing requirements. Our grease trap series is designed and engineered with copolymer polypropylene that out perform other plastic materials and steel units in most severe applications.

"FROG FILTERS"

FOR SOLIDS SEPARATORS

 

​

FILTERS.jpg
gnocchi.png

"FROG CONES" 

FOR FLOOR DRAINS

 

Colors of the cones can vary depending on material availability.

Copyright 2022 - Drainsources.com - All rights reserved  
bottom of page